Watering bag |75l|

Fill the watering bag with water in just a few minutes. It is sufficient for several hours of slow leakage of water at the site of the root system of the plant (5 to 8 hours). The watering bag ensures deep irrigation of the root system. Water flows out of the watering bag on two sides. This will save a lot of time. The bag is made of resistant PVC materials that are UV stable and therefore usable in different seasons. The watering bag is mainly intended for use in dry periods, where there is a lack of precipitation and for transplanted plants. Watering bags are especially suitable for plants with bare trunks. In the case of larger trees, with larger circumferences of trunks, the watering bags can be connected to each other with a built-in zipper.

APPLICATION

1.        Place the watering bag around the trunk of the tree and close the zipper, and if necessary, tie it around the trunk or on the support poles on the upper 'ears' for better leakage.
2.        Pour clean water at the top opening.
3.        After pouring 10 litres of water, place the bag in such a way that the bottom of the bag is levelled with the base.
4.        Fill the bag to full capacity.
5.        The water will drain for 5 to 8 hours.
6.        At the next filling, refill the watering bag with clean water. If you use water-soluble fertilisers, make sure that the fertilisers have completely dissolved.
7.        When the watering bag is not in use, keep it dry in a cool, dry place until the next  use.
8.        Do not use the watering bag at an air temperature below 4°C (degrees Celsius).

HINT

You will further improve soil moisture retention by mulching the plant with wood chips, bark, crushed lava or similar material that retains soil moisture and is plant-friendly.

WARNING

Use clean water – no dirt particles.

Do not move or lift the watering bag filled with more than 10 l of water.

Do not over-water. The watering should be occasional and adapted to weather conditions and location (sunny / shady).